SIGLENT SDS1000D Uživatelský manuál stáhnout pdf (Strana 64)

4. Press the “Type” option button to select “Alternative”.

5. Press the “Channels” option button to select “CH1-CH2”

6. Press the “Source” option button to select “CH1”.

7. Press the CH1 button and turn the “S/div” knob to optimize waveform

display.

8. Press “Mode” option button to select “Edge”, “Pulse”, “Slope” or “Video”.

9. Set the trigger according to trigger edge.

10. Press the “Source” option button to select “CH2”.

11. Press the CH2 button and turn the “S/div” knob to optimize waveform

display.

11. Repeat steps 8 and 9.

2.8.3 Coupling

Use the “Coupling” to make sure the signal that passes the trigger circuit. It is useful for

us to gather a steady wave form.

If you use the trigger coupling, you should press the “TRIGGER” button and then select

“edge” , “Pulse” , “Video” or “Slope” trigger. Then select the “coupling” option in “Set up

menu”.

2.8.4 Position

The horizontal position control establishes the time between the trigger position and the

screen center. You can adjust the horizontal “POSITION” knob control to view waveform

data before the trigger, after the trigger, or some of each. When you change the

horizontal position of a waveform, you are changing the time between the trigger and

the center of the display actually. (This appears to move the waveform to the right or left

on the display.)

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 153 154

Žádné komentáře

SIGLENT SDS1000D Uživatelský manuál Strana 64