SIGLENT SDS1000D Uživatelský manuál Strana 131

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 154
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 130
123
3.3 Catch the single signal
To capture a single event, you need to gather some pre-test knowledge of the
signal in order to correctly set up the trigger level and slope .if you are not sure
the instance of the signal, you can observe it through auto or normal trigger
mode to ensure the trigger level and slope.
The following steps show you how to use the oscilloscope to capture a single
event.
1. Set the Probe option attenuation to 10X and set the switch to 10X on
the probe.
2. Trigger set up
(1) Press “TRIG MENU” button to show the “Trigger Menu”
(2) Under this menu, set the trigger type to “edge”, Edge type is “Rising”,
source is “CH1”, trigger mode is “Single”, coupling is “DC”
(3) Adjust the horizontal time base and vertical scale to the satisfied
range
(4) Turn the “LEVEL” knob to adjust the trigger level
(5) Press the “RUN/STOP” button to start capturing
When the trigger conditions are satisfied, data appears on the display
representing; the data points that the oscilloscope obtained with one
acquisition and press the RUN/STOP button again rearms the trigger
circuit and erases the display.
Zobrazit stránku 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 153 154

Komentáře k této Příručce

Žádné komentáře