SIGLENT SDS1000D Servisní příručka stáhnout pdf (Strana 41)

Service Manual

Chapter 6 Prompting Messages and Troubleshooting

Prompting messages:

■

Trig level at limit! : Mention you that the trigger Level is at a limit when you turn the Trig level

knob.

■

Horizon position at limit! : Mention you that the horizontal position is at a limit when you turn

the horizon position knob.

■

Volts/Div at limit! : Mention you that the vertical voltage have already touched the Min

2MV/div or the Max 5V/div.

■

Volts position at limit! : The system would display this information when the vertical position

is at a limit.

■

Sec/Div at limit! : Prompts that the Volts/Div is at full range while turning the vertical scale

knob.

■

Holdoff time at limit! : Turn the “Universal” knob when holdoff time has been to max or min

value, now the system will clew this information.

■

Functions isn’t useable! : Under several special modes, the some functions could not be

running.

■

No signal! : The system would clew this information when the signal could not match the auto

set condition. (Using in the auto set)

■

Adjust at limit! : You could adjust the pulse width by the universal knob till the pulse width

has reached min20.0ns or max 10.0s.

■

Location Empty! : If you have no stored waveforms or setups on some location, the screen will

display this information when you press the “Recall” button on this location.

■

USB Flash Drive Plug In! : This information will appear when you invert the USB Flash Drive

to the USB Host port.

■

USB Flash Drive Pull Out! : This information will appear when you pull out the USB Flash

1 2 ... 36 37 38 39 40 41 42 43 44

Žádné komentáře

SIGLENT SDS1000D Servisní příručka Strana 41